FAQ: How To Disconnect A Bicycle Chain Without Special Tool?

How do you take off a bike chain without a chain tool?

If your chain has a master link, remove the link by twisting it off with a pair of needle nose pliers. Press the nubs through to the other side to fully remove the link. You may need to use a hammer or wrench to tap the link so that it pops out allowing the chain to separate.

How do you break a chain without pliers?

It will be much easier if you buy a cheap tool, but. Lay the side of the chain on a block of soft wood, take a metal punch, or a nail of around the same diameter as the pin in the link (I used to use a nail), place the nail on the centre of the pin and tap sharply with a small hammer, but not too hard on the pin.

How often should I change my bike chain?

The 2,000-Mile Rule. To avoid this accelerated wear of your cassette and chainrings, a general rule of thumb is to replace your bike’s chain every 2,000 miles. Mind you, this is just a starting point. No two chains will wear at exactly the same rate because no two riders treat their chains the same. 4

How do I remove a split link?

To disconnect this type of link, place one jaw of your pliers on the chain pin, and the other jaw on the open end of the clip. Then squeeze your pliers until the clip pops off. Then you can remove the outer plate and slide out the rest of the link.

You might be interested:  FAQ: Dry Chain Lube Bicycle How To Apply?

What can I use instead of a chain tool?

Removing a Chain Link Without Chain Breaker Tool

  • A Hammer.
  • A thin nail, or something that can hit the chain pin without getting stuck on the chainplates. A 2mm hex wrench can be used as well.
  • You will need something that can withstand a beating but has a hole in it for the pin to pass through.

Leave a Reply

Your email address will not be published. Required fields are marked *