# FAQ: How To Put A Chain On A 10 Speed Bicycle?

## How often should I change my bike chain?

The 2,000-Mile Rule. To avoid this accelerated wear of your cassette and chainrings, a general rule of thumb is to replace your bike’s chain every 2,000 miles. Mind you, this is just a starting point. No two chains will wear at exactly the same rate because no two riders treat their chains the same. 4

## How do I know what chain I need for my bike?

Begin by counting the number of teeth on the largest front sprocket and largest rear. These numbers are often printed right on the sprockets and cogs. Next, measure the distance between the middle of the crank bolt to the rear axle. This is also the chain stay length.

## How do I know if my bike is 10 or 11 speed?

Multiply the front gear number by the rear gear number to get the number of speeds. For example, if you have two front gears and five back gears, you have a 10-speed bike.

## What size bike chain do I need single speed?

1/8″ chains are used exclusively for single speed setups. In addition to the other answers, I found it helpful to read that the nominal width of a chain (1/8 or 3/32) actually refers to the width of the sprocket.

You might be interested:  Readers ask: Why Is A Bicycle Chain Rusting A Chemical Change?

## Why does my chain fell off when I change gears?

Most of the time, a skipping chain is caused by cable stretch. In the first half dozen rides on a new bike your shift cables stretch the most. They can also stretch over time as you ride. Hippley explains, “It takes cable tension to open a derailleur, which shifts your chain between gears.

## What is 8 speed bike?

In a Hub Gear system, the gears are enclosed within the bicycle’s rear hub. When “3 Speed” or “8 Speed” is mentioned in relation to a hub gear, it means that the hub has 3 (or 8) distinct gear ratios.

## How do you put a chain back on a one speed bike?

Start by putting the chain around the small gear on the rear axle of the bike. Next, place some of the chain on the around the big gear by the pedals on the side facing the seat. (This side should be facing down since the bike is upside down.) Keeping one hand on the chain to guide it, slowly start pedaling the bike.