How do I know my bike chain size?
Begin by counting the number of teeth on the largest front sprocket and largest rear. These numbers are often printed right on the sprockets and cogs. Next, measure the distance between the middle of the crank bolt to the rear axle. This is also the chain stay length.
What size is standard bicycle chain?
Chains come in 3⁄32 in (2.4 mm), 1⁄8 in (3.2 mm), 5⁄32 in (4.0 mm), or 3⁄16 in (4.8 mm) roller widths, the internal width between the inner plates. 1⁄8 in (3.2 mm) chains are typically used on bikes with a single rear sprocket: those with coaster brakes, hub gears, fixed gears such as track bicycles, or BMX bikes.
How often should I change my bike chain?
The 2,000-Mile Rule. To avoid this accelerated wear of your cassette and chainrings, a general rule of thumb is to replace your bike’s chain every 2,000 miles. Mind you, this is just a starting point. No two chains will wear at exactly the same rate because no two riders treat their chains the same. 4
In order to shorten the link without a chain tool, you need an alternative tool like a hammer, pliers or thin nail. They will assist you in pushing the pin easily. You can position the chain over a socket, and hit it with a hammer. Then, you can now pass the bolt all throughout the open holes.
Are all bicycle chains the same pitch?
All modern bicycle chains are made to the “one-half inch pitch” standard, meaning from rivet to rivet is nominally 0.5 inches. The sprocket teeth are cut for this same one-half inch standard to accept bicycle chains. However, this does not mean all makes and models of chains are interchangeable.
Are all bicycle chains the same size?
Are all bicycle chains the same size? No, all bicycle chains are not the same size. Size varies on the bike’s numbers of sprockets, speeds, the distance between the front chainring and rear cogs, and the number of teeth on them.
Chain Link Sizes: How to Measure Chain Link Sizes
- Pitch is measured by finding the distance from the center of one pin to the center of the next pin in line.
- Determine your side plate height and thickness by measuring both inside and outside the roller chain to ensure that you’re seeing a good average size.