FAQ: How To Take A Bicycle Chain Off?

How do you take off a bike chain without the tool?

If your chain has a master link, remove the link by twisting it off with a pair of needle nose pliers. Press the nubs through to the other side to fully remove the link. You may need to use a hammer or wrench to tap the link so that it pops out allowing the chain to separate.

Do all bike chains have a master link?

Do all bike chains have a master link? Nope, not all chains have master links. If your bicycle has derailleurs, it means it’s unlikely that your bike’s chain will have a master link.

How do I fix my bike chain without master link?

If you have a standard chain with no master link: Seat the chain in the chain tool, with the pin of the chain tool aligned with a pin in the chain. Turn the handle of the chain tool until you push the pin out far enough that you can break the chain.

How often should I change my bike chain?

The 2,000-Mile Rule. To avoid this accelerated wear of your cassette and chainrings, a general rule of thumb is to replace your bike’s chain every 2,000 miles. Mind you, this is just a starting point. No two chains will wear at exactly the same rate because no two riders treat their chains the same. 4

You might be interested:  Quick Answer: How To Remove Front Wheel Of Road Bicycle?

Do bike chains have a direction?

Chain Routing Some chains are directional and any logos or printed letters should face out towards the mechanic on the drive side. The process for routing the chain is the same for either master link or connecting rivet chains, just make sure to lead with outer plates if using a connecting rivet chain.

How do I remove a quick link from my bike chain?

To disconnect this type of link, place one jaw of your pliers on the chain pin, and the other jaw on the open end of the clip. Then squeeze your pliers until the clip pops off. Then you can remove the outer plate and slide out the rest of the link.

How do you break a chain without a bolt cutter?

If you don’t have bolt cutters or you have a hardened metal chain that bolt cutters won’t cut through, you can use a saw instead. There are a wide variety of saws that will effectively cut through a chain. Pick a saw to use.

  1. Hacksaw.
  2. Metal grinder, such as an angle grinder.
  3. Reciprocating saw.
  4. Coping saw.

Leave a Reply

Your email address will not be published. Required fields are marked *