FAQ: What Pitch Is Bicycle Chain?

What is a normal bicycle chain size?

Chains come in 3⁄32 in (2.4 mm), 1⁄8 in (3.2 mm), 5⁄32 in (4.0 mm), or 3⁄16 in (4.8 mm) roller widths, the internal width between the inner plates. 1⁄8 in (3.2 mm) chains are typically used on bikes with a single rear sprocket: those with coaster brakes, hub gears, fixed gears such as track bicycles, or BMX bikes.

How do I know my bike chain size?

Begin by counting the number of teeth on the largest front sprocket and largest rear. These numbers are often printed right on the sprockets and cogs. Next, measure the distance between the middle of the crank bolt to the rear axle. This is also the chain stay length.

What size is a 9 speed chain?

9 speeds. Chain width is about 6.7 mm. In a pinch, a 10 speed chain can be used. Still, narrower chain is more expensive, doesn’t last as long and will cause a bit slower shifting… but it will work.

What is the difference between bicycle chains?

Chains can vary in side plate shape, sizing, and height. Differences can cause variations in shifting performance between brands and models. Additionally, chains will vary in the quality of steel used. Better chains that are more durable and longer lasting tend to have harder rivets.

You might be interested:  Often asked: How To Remove Bicycle Front Cassette Without Special Tools?

How often should I change my bike chain?

The 2,000-Mile Rule. To avoid this accelerated wear of your cassette and chainrings, a general rule of thumb is to replace your bike’s chain every 2,000 miles. Mind you, this is just a starting point. No two chains will wear at exactly the same rate because no two riders treat their chains the same. 4

Will a #40 chain fit a 35 sprocket?

No. A #40 chain is 1/2″ between the pins and 5/16″ inside width. A #35 is 3/8″ between the pins and 3/16″ inside width. There is no way it will work.

What is chain pitch?

In terms of conveyor chain, pitch is usually defined as the distance between links, as measured from the center of the roller pin on one link to the center of the roller pin on the next link. Note that some precision link conveyors refer to the pitch as the link size.

What is a 35 roller chain?

#35 roller chain is the 2nd size in the ANSI B29. 1 roller chain sizes lineup. It utilizes a small form-factor for tight applications and is manufactured out of high-strength mild carbon steel for shock load and fatigue resistance.

How can I tell if my bike chain is stretched?

Another ballpark method for checking chain wear is by measuring it with a ruler. Pick a rivet and line it up at the zero mark. Count 24 more rivets and your last rivet should be at the 12″ mark of your ruler. If it is off by more than 1/16″ your chain is stretched to the point of replacement.

You might be interested:  FAQ: How To Keep Bicycle Chain Rust Free In Winter?

Are all bicycle chains the same size?

Are all bicycle chains the same size? No, all bicycle chains are not the same size. Size varies on the bike’s numbers of sprockets, speeds, the distance between the front chainring and rear cogs, and the number of teeth on them.

Are 9 and 10-speed chains the same?

The internal/roller width of 9 and 10- speed chains is the same – 2.18mm. The only difference is the spacing of the chainrings. 9 and 10-speed chainrings aren’t spaced the same way, but the differences aren’t humongous.

Leave a Reply

Your email address will not be published. Required fields are marked *