FAQ: Which Chain To Use On A Bicycle?

Does it matter what chain you put on a bike?

The length and number of links doesn’t matter – as all chains are sold too long and you’ll need to remove some links to make it the correct length for your bike.

How do I know which chain to buy for my bike?

When selecting a chain, the first consideration is the number of rear sprockets. The rear cog sets have been made with 5, 6, 7, 8, 9, 10, 11, or 12 sprockets. As the number of cogs on the rear hub increases, the spacing between cogs tends to be reduced.

How often should I change my bike chain?

The 2,000-Mile Rule. To avoid this accelerated wear of your cassette and chainrings, a general rule of thumb is to replace your bike’s chain every 2,000 miles. Mind you, this is just a starting point. No two chains will wear at exactly the same rate because no two riders treat their chains the same. 4

You might be interested:  Quick Answer: How To Remove Bicycle Rear Cassette?

How do I know my chain size?

To measure the chain size, if you have just the sprocket, use calipers to measure between the teeth. Measure from center to center of where the chain roller would set between the teeth that will give you the pitch. Once you know the pitch you can determine what chain size you would need.

What size bike chain do I need single speed?

1/8″ chains are used exclusively for single speed setups. In addition to the other answers, I found it helpful to read that the nominal width of a chain (1/8 or 3/32) actually refers to the width of the sprocket.

How much does it cost to replace a chain on a bike?

Most bike shops will charge about $30 – $50 dollars depending on the bike shop, whether it’s a popular brand or a “mom & pop” shop. You may also want to take into consideration that the chain itself may cost $30 – $50 dollars but then the labor cost to replace this might run you an additional $10 dollars.

Why does my bike chain slip when I pedal hard?

Most of the time, a skipping chain is caused by cable stretch. In the first half dozen rides on a new bike your shift cables stretch the most. They can also stretch over time as you ride. Hippley explains, “It takes cable tension to open a derailleur, which shifts your chain between gears.

How often should I lube my bike chain?

Bicycle Tutor recommends cleaning and lubricating your bike’s drive chain at least once every month to maintain optimal performance and protection. The chain and drivetrain are typically the dirtiest parts of your bike, and this dirt is bad news for bike longevity and performance.

You might be interested:  Quick Answer: What Causes Bicycle Chain Jump Sprocket?

How long does a bicycle chain last?

Replacing your chain regularly can prolong the life of your drivetrain. Most mechanics agree that you should replace your chain about every 2,000 to 3,000 miles, depending on your riding style.

What is the difference between.325 and 3/8 chain?

The three-eighths chain is a beefier saw and better suited to one that has more horsepower. It has larger teeth and a heavier duty chain, so it requires more horsepower to operate correctly. 325-inch chain for those saws between 40 and 60 cc.

How do I know my roller chain size?

Roller Chain Identification Most roller chain has the size stamped right into the side plates. You may see something like “40”, “C2080H” or “10B” stamped in, which the industry number that represents the chain size. Old chains will most likely need to be cleaned in order to see the size.

How do I choose a chain sprocket size?

Determine the number of teeth of the small sprocket. The number of teeth for the large sprocket is determined by multiplying the number of teeth for the small sprocket by the speed ratio. More than 15 teeth on the small sprocket is recommended. The number of teeth on the large sprocket should be less than 120.

Leave a Reply

Your email address will not be published. Required fields are marked *