What tools are need to remove a crank arm?
- Appropriate wrench to remove crank bolt/nut: CCW-5 Crank Wrench. Hex wrench. MW-SET. 2 Combination Wrenches. PAW-12 Adjustable Wrench.
- Crank puller: CCP-22 for square taper cranks. CCP-44 for splined cranks. CWP-7 – universal fit.
- Torque wrench.
- Thread preparation: ASC-1. PPL-1.
What can I use instead of a crank puller?
You can also pry the threads out or remove them by slowly threading the bolt, depending on the crank arm type of your bicycle. Use a bolt or a spanner tool to remove and loosen the washers.
Almost anything can be taken apart without proper tools, including bottom brackets. it, but it can be done. The right tool for the job(any job) makes life much easier and will lower your frustration level by leaps and bounds. If it is a Square taper, isis or octalink then no.
How do you remove a Shimano crank without a tool?
Simply place the crank extractor inside the crank bolt hole, rotating it clockwise until tight, before turning it counterclockwise so that the crank comes off. Remove the crank from the other side of the bike in the same manner and, voila, you’ll have officially removed your crankset just like that.
Are crank pullers universal?
The universal design of the CWP-7 has a rotating tip pressed into each end of the tool (11.3mm and 16.3mm) so it will remove both square taper and splined (ISIS Drive™, Octalink®) crank arms.
How do you remove a racing turbine crank?
To remove the arm, use a 8mm hex wrench on the crank bolt and turn counter-clockwise. One-key system will remove arm from the spindle. After removing the right arm, pull the left arm to remove. It may be necessary to use a mallet and tap spindle to free the arm.