Often asked: How To Properly Lubricate A Bicycle Chain?

Is it OK to use WD-40 on bike chain?

All you need to do is rinse the bike chain to remove any mud and thick dirt. Spray the WD-40 Bike Degreaser onto the surface of your bike chain and give it adequate time to work. On top of that, the WD-40 Bike Degreaser can be used for the cleaning and degreasing of other moving parts as well.

Do you lubricate a bicycle chain?

A bicycle chain needs lubricant to overcome mechanical resistance, prevent rust and wear, and keep your drivetrain in tip-top condition. If not used properly, the same lubricating compounds designed to protect and enhance drivetrain performance are inherently at odds with the very purpose for which they were created.

What is the best lubricant for a bike chain?

Best bike chain lubes – our picks

  • Rock N Roll Gold.
  • Silca Super Secret Chain Lube.
  • Green Oil Wet Lube.
  • Finish Line Wet.
  • CeramicSpeed UFO Ceramic lube.
  • Tru Tension All Weather.
  • Molten Speedwax. Wax chains take a bit of extra work, but are well worth the effort.
  • Squirt chain lube. High-performance, wax-based lube.
You might be interested:  Readers ask: How To Remove Spray Paint From Your Bicycle Without Taking Off The Under Coat?

Can I use Vaseline on my bike chain?

The fluid consists of two components – Vaseline, which proved to be one of the best lubricants, and a special kind of thinner that helps to get the Vaseline deep into the chain links. Once the thinner evaporates, Vaseline will do its best to make your chain running quietly.

How often should I lubricate my bike chain?

Bicycle Tutor recommends cleaning and lubricating your bike’s drive chain at least once every month to maintain optimal performance and protection. The chain and drivetrain are typically the dirtiest parts of your bike, and this dirt is bad news for bike longevity and performance.

Why is WD-40 bad for bike chains?

WD40 is primarily a solvent, which means that it dissolves contaminates so parts get nice and clean. As a solvent, WD-40 will strip away any existing lubricant, leaving your chain, and drivetrain dryer than before application. This means that using WD-40 as a chain lubricant is worse than using no lube at all.

What should you not use WD-40 on?

But Don’t Spray It On:

  • Door hinges. Sure, WD-40 will stop the squeaking, but it also attracts dust and dirt.
  • Bike chains. WD-40 can cause dirt and dust to stick to a chain.
  • Paintball guns. WD-40 can melt the seals in the guns.
  • Locks.
  • iPods and iPads.

Can you use olive oil on bike chain?

Yes, because an extra virgin olive oil on a bike chain is better than no oil at all. Olive oil will never be as effective as proper lube oil, but it can help a lot when you are in an emergency situation. It can provide a temporary effect, which should be enough to get you to a bike shop nearly for proper fixing.

You might be interested:  Quick Answer: How To Close A Bicycle Chain Master Link?

Can I use baby oil on my bike chain?

Be sure to use bicycle lubricant, not WD40 or another solvent. Putting anything other than bike lube on your components can cause them to corrode faster. I’ve had customers tell me they’ve used motor oil, baby oil, coconut oil, vegetable oil, etc.

Can I use engine oil as chain lube?

Usage of engine oil or grease is not at all recommended over a proper chain lubricant. Grease wont penetrate into the O rings and X rings as compared to chain lubricant. Whereas engine oil lasts only for a few days which reduces the life of your chain and sprocket.

Is White Lithium grease good for bike chains?

Yes, but it’s not a good idea. Even applied sparingly, it will pick up way too much dirt and make a mess. If you oil or otherwise try to lubricate the chain later on, all this dirt will flow inside the bearings and cause the chain to wear out prematurely.

Can I use silicone spray on my bike chain?

Re: Silicon spray Silicon spary will work as a chain lube. So will motor oil, WD 40 and probably yak milk. You’re still better off using a specific bike chain lube. I use silicon spray on my frame to keep it all purdy like, as well as the stanchions on my suspension forks.

Leave a Reply

Your email address will not be published. Required fields are marked *