Question: How To Remove Rear Sprocket On A Bicycle?

How do you get a sprocket off a bike?

Wrap the chain whip tool around the largest sprocket and secure it. The chain whip tool holds the cassette in place so that you can loosen the lockring. Place the sprocket removal tool around the lockring. Use a crescent wrench to turn the lockring counter- clockwise, so that you can loosen and remove it.

What tools do I need to remove a bike cassette?

The lockring is designed to hold the cogs of the cassette in place on the hub. In order to remove and replace your cassette, you need to unscrew this lockring. You’ll need three tools to do this: a chain whip, a cassette lockring remover and a large adjustable crescent wrench.

Can you remove a sprocket?

You’ll need two chain whips to loosen the sprocket. One to keep the cassette in place while you unscrew the sprocket with the other. I used a chain whip from Decathlon to loosen the sprocket.

How do I remove a freehub body?

The axle is independent of the freehub.

  1. Remove set screw from side of drive side locknut.
  2. Hold non-drive side cone with cone wrench. Loosen and remove drive side locknut.
  3. Pull freehub to remove. Use care not to loose small parts. Note orientation of pawls as you remove freehub.

Where is the sprocket on a bike?

Perhaps the most common form of sprocket may be found in the bicycle, in which the pedal shaft carries a large sprocket-wheel, which drives a chain, which, in turn, drives a small sprocket on the axle of the rear wheel.

Leave a Reply

Your email address will not be published. Required fields are marked *