What can you use instead of a crank puller?
You can also pry the threads out or remove them by slowly threading the bolt, depending on the crank arm type of your bicycle. Use a bolt or a spanner tool to remove and loosen the washers.
How do you remove a Shimano crank without a tool?
Simply place the crank extractor inside the crank bolt hole, rotating it clockwise until tight, before turning it counterclockwise so that the crank comes off. Remove the crank from the other side of the bike in the same manner and, voila, you’ll have officially removed your crankset just like that.
Are crank pullers universal?
The universal design of the CWP-7 has a rotating tip pressed into each end of the tool (11.3mm and 16.3mm) so it will remove both square taper and splined (ISIS Drive™, Octalink®) crank arms.
How do you remove a self extracting crankshaft?
- Leave the retaining ring of the self-extracting systems in place in the arm. Do not remove the retaining ring.
- Begin unthreading crank bolt using hex wrench. Continue loosening until crank arm slides off spindle.
- Remove remaining crank arm.
Are there different types of crank pullers?
Crank pullers are used for the removal of basic three-piece crank types: square-type spindle arms, and splined-type spindle arms. Square tapered spindles are made with a slight slope or taper. Cranks used with a loose bolt will result in movement and wear between steel spindle and the sqaure hole the crank.
Almost anything can be taken apart without proper tools, including bottom brackets. it, but it can be done. The right tool for the job(any job) makes life much easier and will lower your frustration level by leaps and bounds. If it is a Square taper, isis or octalink then no.