- 1 How tight should your bicycle chain be?
- 2 Can you over tighten a bike chain?
- 3 Is it bad to have your chain tight?
- 4 Why does my bike chain skip when I pedal?
- 5 Why does my chain go tight then loose?
- 6 How much tension should be on a chainsaw chain?
- 7 How much does it cost to tighten a chain on a chainsaw?
- 8 Why does my bike chain slip when I pedal hard single speed?
- 9 How often should I change my bike chain?
How tight should your bicycle chain be?
Chain Tension There should be approximately one half inch of movement in the chain up and down at a point half way between the front and rear sprockets. To change the tension loosen one of the axle-nuts and move the wheel forward or backward slightly and snug it up again.
Can you over tighten a bike chain?
If it moves too far in either direction it means it isn’ t tight enough and should be pushed a bit more on the tire. If it’s too tight you will not be able to turn the pedals, so it’s important to make sure that you get this step just right.
Is it bad to have your chain tight?
Too tight is as bad as too loose, but it’ll only take minutes to get it right. You should check and adjust your chain every 500 miles (805 km), and more often for a dirt bike. It’s also a great time to look for kinks or rust, and to give your chain a quick cleaning and lubrication, too.
Why does my bike chain skip when I pedal?
Most of the time, a skipping chain is caused by cable stretch. In the first half dozen rides on a new bike your shift cables stretch the most. They can also stretch over time as you ride. Shift down into the smallest ring in the rear cassette again, and press your shifter again to see if the bike shifts properly.
Why does my chain go tight then loose?
Re: tight then loose Chain Could be: bent crank, over stretched chain, misaligned chain, off center chainwheel, tweaked rear hub, bad freewheel. Most likely is an off center chainwheel: Remove the chain and check how far the chainwheel moves front to back, like you are truing a wheel with a hop in it.
How much tension should be on a chainsaw chain?
Before explaining the tensioning steps, we should explain what proper chainsaw chain tension looks like. A properly-tensioned chainsaw chain should still be just a little loose on the chainsaw guide bar, but the chain needs to be tight enough that you can’t pull the drive links out of the bar nose.
How much does it cost to tighten a chain on a chainsaw?
It should “give” about a 1/4 inch from the bar without much effort. Finally, while still holding up on the tip of the bar, tighten the bar nuts. Proper chainsaw chain tension is safer, it cuts better and it will extend the life of both your chainsaw and your chain.
Why does my bike chain slip when I pedal hard single speed?
Anyway, when you’re pedaling hard, there is tension in the top section of the chain, between the ring teeth and the cog. Under this tension, they stay engaged even if the returning-to-ring section of the chain is sagging.
How often should I change my bike chain?
The 2,000-Mile Rule. To avoid this accelerated wear of your cassette and chainrings, a general rule of thumb is to replace your bike’s chain every 2,000 miles. Mind you, this is just a starting point. No two chains will wear at exactly the same rate because no two riders treat their chains the same. 4