- 1 How tight should motorized bike chain be?
- 2 Why is my bicycle chain tight and loose?
- 3 What happens if bike chain is tight?
- 4 Is a tight BMX chain bad?
- 5 Why does my BMX chain have a tight spot?
- 6 Why does my BMX chain keep coming loose?
- 7 Is my chain to tight?
- 8 Can I use wd40 to clean motorcycle chain?
- 9 How do you know if your motorcycle chain is tight?
How tight should motorized bike chain be?
1.2–1.6 inches (30–40 mm) is typical for streetbikes, while dirt bikes may need 1.4–2.0 inches (35–50 mm) of slack. Step 4 To adjust the drive chain, loosen the axle nut a couple of turns. If all you have is a short wrench, you can stand on it to get the nut loose.
Why is my bicycle chain tight and loose?
Re: tight then loose Chain Could be: bent crank, over stretched chain, misaligned chain, off center chainwheel, tweaked rear hub, bad freewheel. Most likely is an off center chainwheel: Remove the chain and check how far the chainwheel moves front to back, like you are truing a wheel with a hop in it.
What happens if bike chain is tight?
When a motorcycle chain is too tight, it’ ll put stress on several components of the bike and cause the sprockets to wear faster, make the engine work harder, and cause the suspension to be tight and uncomfortable. Ultimately, a tight chain on a motorcycle may break leaving you with no power.
Is a tight BMX chain bad?
Some bike riders like to keep the bike chain too tight, and it makes the cranks hard to spin, while others leave it wobbling a little too much that it comes off. If your BMX chain is too tight, it will create a rattling sound. This noise could not only be awkward for your viewers but also could prove to be dangerous.
Why does my BMX chain have a tight spot?
If you feel your BMX chain has a “tight spot,” the first thing you should check is the Sprocket. This tight spot on a BMX bike is usually caused by the bolts behind the Sprocket being loosened. A simple tightening of the bolts should fix a tight-spot.
Why does my BMX chain keep coming loose?
You will be stressing your rear triangle and putting load on it that can cause a loose or super tight chain. I usually pull my wheel back and then making sure the wheel is kicked a little to the non drive side.
Is my chain to tight?
The first step is to understand the problem of a loose chain or if the chain is too tight. The chain should be tight enough that it only allows you to move it up and down about half an inch. If there is no slack in the chain then it is too tight. And if there is too much slack then you need to tighten that chain.
Can I use wd40 to clean motorcycle chain?
What can you use to clean your motorbike chain? WD-40® Specialist ® Motorcycle Chain Cleaner is specifically designed for the removal of dirt, debris and old protecting products from motorbike chains. The formula will soften and solubilise all grease and oils to lift the contaminants with ease.
How do you know if your motorcycle chain is tight?
Well, there are a few tell-tale signs that your chain tension isn’t set correctly, such as:
- A ‘wurring’ sound as you accelerate.
- Knocking between gear changes.
- The chain looking under strain when you sit on the bike.