Quick Answer: How To Remove Bicycle Flywheel?

How do you remove a bike freewheel without special tools?

The quickest and easiest way to remove a freewheel without a freewheel tool. Place the bulk of the freewheel in the vice and clamp it extremely hard until you begin to crush it enough to bind the guts all up. Then turn it counterclockwise.

How do I remove a freehub body?

The axle is independent of the freehub.

  1. Remove set screw from side of drive side locknut.
  2. Hold non-drive side cone with cone wrench. Loosen and remove drive side locknut.
  3. Pull freehub to remove. Use care not to loose small parts. Note orientation of pawls as you remove freehub.

How do you remove the rear sprocket on a bicycle?

Cassette Lockring Removal

  1. Mount bike in repair stand and remove rear wheel from bike.
  2. Remove quick-release skewer.
  3. Inspect cassette and select correct type of remover.
  4. Engage remover into splines/notches.
  5. Install quick-release skewer and install skewer nut on outside of remover.
  6. Snug skewer nut against remover.

What is a free wheel on a bicycle?

In mechanical or automotive engineering, a freewheel or overrunning clutch is a device in a transmission that disengages the driveshaft from the driven shaft when the driven shaft rotates faster than the driveshaft. In a fixed-gear bicycle, without a freewheel, the rear wheel drives the pedals around.

Can you remove a sprocket?

You’ll need two chain whips to loosen the sprocket. One to keep the cassette in place while you unscrew the sprocket with the other. I used a chain whip from Decathlon to loosen the sprocket.

Leave a Reply

Your email address will not be published. Required fields are marked *