Quick Answer: What Does It Mean When My Bicycle Peddels Work With The Chain But My Tiers Wont Spin?

Why won’t my front tire move on my bike?

The most likely problem is that the brakes are rubbing. If you pick up the front of the bike, hold your head near the brakes and spin the wheel you shouldn’t hear any noise from the brakes. If you do, then the brakes are rubbing and that’s the first problem to be fixed.

Why is my back wheel on my bike not moving?

Check the rear derailleur – is the chain running freely though it. If not, check the chain line and make sure the small sprockets are free spinning. Check the chain line though the front end. Is the chain clear of the derailleur and sitting properly on the chain ring.

Why wont my bike go when I pedal?

There’s a chain that connects the large cog between the pedals to the smaller sprocket at the centre of the back wheel. If the chain has come off either of those, the pedals will turn but the back wheel may not. If the chain is stuck, then the pedals may not even turn.

Why is it hard to pedal my bike?

A bike is hard to pedal because it’s in the incorrect gear for the terrain or because of excessive friction. Changing to a smaller gear or reducing the friction makes riding easier. The cause of friction can be brake pads rubbing against the rim or disc, insufficient chain lubrication or low tire pressure.

You might be interested:  FAQ: How To Remove Bicycle Tires?

How tight should front bike be?

So how tight should front bike wheels be? Tight enough that the wheel does not feel loose when you rotate it. You can test this by turning the bike upside down and spinning it. If it is wobbling or there is any sideways movement, it is too loose.

How do you fix ghost pedals?

The end result will be sporadic ghost pedaling when the bicycle is coasting. To fix this issue, you will have to replace the broken pawls, the freehub body, or the entire hub.

How tight should rear bike wheels be?

You want your rear axle very tight. 150 in/lb is about standard. If it is not tight it will allow the rear wheel to move around and it ties your rear triangle together. Basically the whole back of the bike will feel sloppy.

How long should my bike wheel spin?

You should be getting more than 10 seconds. One test for excessive drag is to watch the wheel as it stops spinning. It should oscillate back and forth two or three times as the heaviest section of the wheel settles to the bottom.

Can you repair a freewheel?

How to fix freewheel or freehub not engaging? One option is to take the freewheel or the freehub apart, get all the pawls moving, and rebuild it with new grease or oil. The second method is to pour some mineral or other low-density oil through the gaps and keep rotating until everything starts working again.

Leave a Reply

Your email address will not be published. Required fields are marked *