Readers ask: How Do I Shorten A Bicycle Chain?

How do I make my bike chain shorter?

Shortening the chain In order to shorten the link without a chain tool, you need an alternative tool like a hammer, pliers or thin nail. They will assist you in pushing the pin easily. You can position the chain over a socket, and hit it with a hammer.

How do you shorten a bike chain without a tool?

If you don’t have a chain tool use a small nail and a pair of pliers to get the pins out of the links. Once you have the right length, make sure that the chain is properly reattached. Lubricate and put the chain back on.

Can I shorten a bike chain by one link?

Unless using a special half link (as mentioned and linked to by Chris H) to shorten a chain you have to remove the same number of outer and inner plate links. The distance between the joining pins is 0.5 inch so joined chain are always a multiple of whole inches long.

Can you shorten chain length?

Simply clip the chain to your desired length (I usually hold mine around my neck while looking in the mirror so I can see exactly how much I need to cut off, I mark the spot with my fingers & then clip the chain) & then insert a jump ring into the last link.

You might be interested:  How To Size Chain Withut Old Chain Bicycle?

Why does bike chain jump?

Most of the time, a skipping chain is caused by cable stretch. In the first half dozen rides on a new bike your shift cables stretch the most. They can also stretch over time as you ride. Hippley explains, “It takes cable tension to open a derailleur, which shifts your chain between gears.

Do I need to shorten my bike chain?

To avoid damage, there should be at least one full link of overlap when the chain is put around the big chainring and big sprocket (with the rear derailleur bypassed). Unless the chain was too long to begin with (which is unlikely), you should get a new chain.

Do bike chains have a master link?

Replacement Pin or Master Link: New chains will come with either a new pin, or a specialized link called a master link, to connect the two ends of the chain together.

Should I take a link out of my chain?

It’s better to take off too few links at first than to take off too many. It’ll be easier to take off an extra link or 2 than to add several links back on. Clamp the next link of the chain.

How do I know my bike chain size?

Begin by counting the number of teeth on the largest front sprocket and largest rear. These numbers are often printed right on the sprockets and cogs. Next, measure the distance between the middle of the crank bolt to the rear axle. This is also the chain stay length.

How do you cut chain length?

How to Cut Chain Links

  1. Turn the set screw on the bolt cutters to adjust the width of the blades to accommodate the size of the chain links.
  2. Center the chain link between the blades.
  3. Grip one handle of the bolt cutter in each hand.
  4. Push both handles down at the same time to cut the link.

Leave a Reply

Your email address will not be published. Required fields are marked *