Readers ask: How Shorten A Bicycle Chain?

How do I make my bike chain shorter?

Shortening the chain In order to shorten the link without a chain tool, you need an alternative tool like a hammer, pliers or thin nail. They will assist you in pushing the pin easily. You can position the chain over a socket, and hit it with a hammer.

How do you shorten a bike chain without a chain tool?

If you don’t have a chain tool use a small nail and a pair of pliers to get the pins out of the links. Once you have the right length, make sure that the chain is properly reattached. Lubricate and put the chain back on.

Can I shorten a bike chain by one link?

Unless using a special half link (as mentioned and linked to by Chris H) to shorten a chain you have to remove the same number of outer and inner plate links. The distance between the joining pins is 0.5 inch so joined chain are always a multiple of whole inches long.

Does my bike chain have a master link?

Bikes that typically do have chains with master links are BMX bikes and one- or three-speed town bikes with internal gears. You can also identify if your chain should have a master link by measuring the width of the gap between the link plates. If the width is 1/8 inch, your chain should have a master rivet.

You might be interested:  How To Remove Bicycle Tube Valve Core?

How do you fit a bike chain without a tool?

You don’t need any tool whatsoever. You can do this by connecting the master link on the drivetrain’s top side while the chain sits on both chainrings and the cassette. Once you put the master link in place, to connect it completely, just hold the brakes and step on the pedal.

Why does bike chain jump?

Most of the time, a skipping chain is caused by cable stretch. In the first half dozen rides on a new bike your shift cables stretch the most. They can also stretch over time as you ride. Hippley explains, “It takes cable tension to open a derailleur, which shifts your chain between gears.

Should I shorten my bike chain?

You either deliberately run the chain long enough to handle your mistakes in shifting (for big/big) or you don’t. You should have better shifting theoretically with a shorter chain, but if you shift big/big by accident you do have a problem.

Do I need to shorten my bike chain?

To avoid damage, there should be at least one full link of overlap when the chain is put around the big chainring and big sprocket (with the rear derailleur bypassed). Unless the chain was too long to begin with (which is unlikely), you should get a new chain.

What is chain master link?

A master link or quick-release link is a roller chain accessory that allows convenient connection and disconnection of a chain without the need for a chain tool. It acts as a set of the chain’s outer plates, so joining two sets of the chain’s inner plate ends. Such master links may or may not be re-usable.

Leave a Reply

Your email address will not be published. Required fields are marked *