- 1 What causes chain rub?
- 2 Should my front derailleur rubs chain?
- 3 Why does my mountain bike chain click when I’m riding it?
- 4 Why is my front derailleur not shifting?
- 5 Should I adjust the front or rear derailleur first?
- 6 Why does my derailleur hit my cassette?
- 7 Can you use wd40 on bike chain?
- 8 How often should I lube my bike chain?
What causes chain rub?
The reason the chain rubs is because the cable is too loose. And when it’s too loose, shifting onto the large chainring results in only a partial shift. With sufficient tension on the derailleur cable, the derailleur cage will move to its full outside limit and there will be clearance for the chain – and no rubbing.
Should my front derailleur rubs chain?
The front derailleur should shift the chain between chainrings without throwing the chain off the extreme outer and inner rings. It is possible that the front derailleur will rub the chain slightly even on properly adjusted bikes.
Why does my mountain bike chain click when I’m riding it?
How to Fix a Clicking Chain. A clicking noise often comes from your chain wanting to jump up or down a gear on the rear cassette. This can typically be fixed by adjusting the tension of the cable that runs from your shifter to your rear derailleur. The clicking could be caused by a bent derailleur hanger.
Why is my front derailleur not shifting?
Common Front Derailleur Problems. Front derailleurs may cause sluggish or inaccurate shifting because (A) the derailleur body is not positioned properly, (B) the derailleur limit screws are not adjusted correctly, (C) the mechanism is dirty or (D) the cable is damaged or improperly tensioned.
Should I adjust the front or rear derailleur first?
In a nutshell, adjust the front derailleur first, then the rear. If the derailers just need minor tweaking (they are basically in adjustment but are “not quite right”) then you adjust the one that is obviously wrong, check the overall adjustment again, then again adjust what needs adjusting.
Why does my derailleur hit my cassette?
Most derailleurs will drag on the top cog of a 34 t cassette when the bike is upside down, but not when it’s right-side up. If it does it when it’s right side up, shorten the loop of cable on the derailleur. Shortening the housing loop is not the best idea. You should adjust the b-tension screw.
Can you use wd40 on bike chain?
All you need to do is rinse the bike chain to remove any mud and thick dirt. Spray the WD-40 Bike Degreaser onto the surface of your bike chain and give it adequate time to work. On top of that, the WD-40 Bike Degreaser can be used for the cleaning and degreasing of other moving parts as well.
How often should I lube my bike chain?
Bicycle Tutor recommends cleaning and lubricating your bike’s drive chain at least once every month to maintain optimal performance and protection. The chain and drivetrain are typically the dirtiest parts of your bike, and this dirt is bad news for bike longevity and performance.