- 1 How long should a bicycle chain be?
- 2 How do I know if my chain is too short?
- 3 How can I tell if my bike chain is stretched?
- 4 How do I know my chain size?
- 5 How do I set the size of a chain link?
- 6 What is a chain stay?
- 7 How many links make a chain?
- 8 Do bike chains have a direction?
- 9 What kind of lube should I use on my bike chain?
How long should a bicycle chain be?
Using a ruler, a new chain should measure exactly 12 inches across 12 links, from middle of pin to middle of pin. The number most commonly agreed on for a worn chain is one percent elongation between links.
How do I know if my chain is too short?
You should also see two slight bends at each jockey wheel of the rear derailleur. If the chain is too short, this shift is difficult to make and the derailleur cage is stretched out and almost parallel to the chainstay. If the chain is really short, then you might not even be able to shift into the largest cog.
How can I tell if my bike chain is stretched?
Another ballpark method for checking chain wear is by measuring it with a ruler. Pick a rivet and line it up at the zero mark. Count 24 more rivets and your last rivet should be at the 12″ mark of your ruler. If it is off by more than 1/16″ your chain is stretched to the point of replacement.
How do I know my chain size?
Begin by counting the number of teeth on the largest front sprocket and largest rear. These numbers are often printed right on the sprockets and cogs. Next, measure the distance between the middle of the crank bolt to the rear axle. This is also the chain stay length.
Chain Link Sizes: How to Measure Chain Link Sizes
- Pitch is measured by finding the distance from the center of one pin to the center of the next pin in line.
- Determine your side plate height and thickness by measuring both inside and outside the roller chain to ensure that you’re seeing a good average size.
What is a chain stay?
What is the chainstay? The chainstay or “stays” = The pair of frame tubes that joins the bottom bracket shell to the rear axle holders (the slots the back wheel goes in). This means that the chain stays connect the bottom bracket (BB) to the center of the back wheel.
The chain is a unit of length equal to 66 feet (22 yards). It is subdivided into 100 links or 4 rods.
Do bike chains have a direction?
Chain Routing Some chains are directional and any logos or printed letters should face out towards the mechanic on the drive side. The process for routing the chain is the same for either master link or connecting rivet chains, just make sure to lead with outer plates if using a connecting rivet chain.
What kind of lube should I use on my bike chain?
Use a light, waterproof lube such as Boeshield T-9 Waterproof Lubricant. For wet-weather conditions, try Pedro’s Chainj. Never Use: Motor oil—it contains acids and particles of metal that can compromise a chain’s strength and cause it to wear more quickly.