Readers ask: What Size Chain To Buy Bicycle?

How do I know my bike chain size?

Add the multiplied chainstay length, the divided number of teeth for the chainring and rear sprocket, and add 1 (or 2.5 cm). The result is the ideal chain length for your bike. For example, you’d add 32.5, 13, 7 and 1 to get 53.5. The length of the chain should be 53.5 inches or 135.89 cm.

What size chain does a bicycle use?

The chain in use on modern bicycles has a 1⁄2 inch (12.7 mm) pitch, which is the distance from one pin center to another, ANSI standard #40, where the 4 in “#40” indicates the pitch of the chain in eighths of an inch; and is standard 606 (metric) #8, where the 8 indicates the pitch in sixteenths of an inch.

What replacement chain do I need for my bike?

A reading of 0.5 to 0.75 means you should replace your chain. A reading of 0.75 or higher means you not only need to replace your chain, but you should also check the condition of your cassette and chainrings to see if the stretched chain has caused excessive wear to these parts.

You might be interested:  Readers ask: What Size Bicycle Chain Do I Need For A Bike With A Low Cog Count Of 13?

What is the difference between bicycle chains?

Chains can vary in side plate shape, sizing, and height. Differences can cause variations in shifting performance between brands and models. Additionally, chains will vary in the quality of steel used. Better chains that are more durable and longer lasting tend to have harder rivets.

What size bike chain do I need single speed?

1/8″ chains are used exclusively for single speed setups. In addition to the other answers, I found it helpful to read that the nominal width of a chain (1/8 or 3/32) actually refers to the width of the sprocket.

How often should I change my bike chain?

The 2,000-Mile Rule. To avoid this accelerated wear of your cassette and chainrings, a general rule of thumb is to replace your bike’s chain every 2,000 miles. Mind you, this is just a starting point. No two chains will wear at exactly the same rate because no two riders treat their chains the same. 4

Are all bicycle chains the same size?

Are all bicycle chains the same size? No, all bicycle chains are not the same size. Size varies on the bike’s numbers of sprockets, speeds, the distance between the front chainring and rear cogs, and the number of teeth on them.

Are 6 7 8 speed chains the same?

5, 6, 7 and 8 speed chains Shimano, SRAM and Campagnolo all use the same chain with 8 speeds. Chain for 7 speeds is a bit wider – 7.3 mm, while a 6 speed one is substantially wider – 7.8 mm.

How often should I lube my bike chain?

Bicycle Tutor recommends cleaning and lubricating your bike’s drive chain at least once every month to maintain optimal performance and protection. The chain and drivetrain are typically the dirtiest parts of your bike, and this dirt is bad news for bike longevity and performance.

You might be interested:  How To Remove A Bicycle Tire?

Why does my bike chain slip when I pedal hard?

Most of the time, a skipping chain is caused by cable stretch. In the first half dozen rides on a new bike your shift cables stretch the most. They can also stretch over time as you ride. Hippley explains, “It takes cable tension to open a derailleur, which shifts your chain between gears.

How many miles does a bike chain last?

Expect between 1,500 and 3,000 miles from a 10-speed chain. It helps to establish what counts as ‘worn out’. A chain is worn enough to affect transmission efficiency when it lengthens by 0.75% but has some life left if extended mileage is the aim, in which case it should ideally be replaced when it lengthens by 1%.

How can I tell if my bike chain is stretched?

Another ballpark method for checking chain wear is by measuring it with a ruler. Pick a rivet and line it up at the zero mark. Count 24 more rivets and your last rivet should be at the 12″ mark of your ruler. If it is off by more than 1/16″ your chain is stretched to the point of replacement.

What is chain stay?

the chain stay is the part of the frame thats nearest to your chain, and often gets big gashes in it from your chain hitting it. often people have something covering there chainstay to protect it from the chain hitting it.

Leave a Reply

Your email address will not be published. Required fields are marked *