Readers ask: What Size Or Guage Is A Bicycle Chain?

How do I know what size my bicycle chain is?

Begin by counting the number of teeth on the largest front sprocket and largest rear. These numbers are often printed right on the sprockets and cogs. Next, measure the distance between the middle of the crank bolt to the rear axle. This is also the chain stay length.

What size is a standard bicycle chain?

All modern bicycle chains are made to the “one-half inch pitch” standard, meaning from rivet to rivet is nominally 0.5 inches. The sprocket teeth are cut for this same one-half inch standard to accept bicycle chains. However, this does not mean all makes and models of chains are interchangeable.

What size is a 9 speed chain?

9 speeds. Chain width is about 6.7 mm. In a pinch, a 10 speed chain can be used. Still, narrower chain is more expensive, doesn’t last as long and will cause a bit slower shifting… but it will work.

How is chain wear measured?

Another ballpark method for checking chain wear is by measuring it with a ruler. Pick a rivet and line it up at the zero mark. Count 24 more rivets and your last rivet should be at the 12″ mark of your ruler. If it is off by more than 1/16″ your chain is stretched to the point of replacement.

You might be interested:  What Is Bicycle Chain Oil?

Is my bike chain too short?

If the chain is too short, this shift is difficult to make and the derailleur cage is stretched out and almost parallel to the chainstay. If the chain is really short, then you might not even be able to shift into the largest cog. Before you remove the chain, make sure it’s on the small chainring and smallest cog.

Are all bicycle chains the same size?

Are all bicycle chains the same size? No, all bicycle chains are not the same size. Size varies on the bike’s numbers of sprockets, speeds, the distance between the front chainring and rear cogs, and the number of teeth on them.

What is the most common bike chain size?

Chains come in 3⁄32 in (2.4 mm), 1⁄8 in (3.2 mm), 5⁄32 in (4.0 mm), or 3⁄16 in (4.8 mm) roller widths, the internal width between the inner plates. 1⁄8 in (3.2 mm) chains are typically used on bikes with a single rear sprocket: those with coaster brakes, hub gears, fixed gears such as track bicycles, or BMX bikes.

Are 9 and 10 speed chains the same?

The internal/roller width of 9 and 10- speed chains is the same – 2.18mm. The only difference is the spacing of the chainrings. 9 and 10-speed chainrings aren’t spaced the same way, but the differences aren’t humongous.

How often should I change my bike chain?

The 2,000-Mile Rule. To avoid this accelerated wear of your cassette and chainrings, a general rule of thumb is to replace your bike’s chain every 2,000 miles. Mind you, this is just a starting point. No two chains will wear at exactly the same rate because no two riders treat their chains the same. 4

You might be interested:  FAQ: How To Remove Bearing Cups Bicycle?

How often should I lube my bike chain?

Bicycle Tutor recommends cleaning and lubricating your bike’s drive chain at least once every month to maintain optimal performance and protection. The chain and drivetrain are typically the dirtiest parts of your bike, and this dirt is bad news for bike longevity and performance.

Leave a Reply

Your email address will not be published. Required fields are marked *